User's Manual

Altai A8n (ac) Series Super WiFi Base Station

Installation Guide

2. Loosely connect all the RF cables from each RF port. Do not tighten

up any of the connections.

3. Secure the RF cable bundles to the pole.

4. Tighten the RF cable connectors around the A8n (ac) series 5GHz

antenna ports with a torque wrench to the proper torque limit to

ensure that correct internal seals and surface contacts are made. If

a torque wrench is not available, first tighten the connector to finger

tight, then tighten it with a wrench for an additional ⅛ to ¼ turn from

the finger tight position.

5. Weatherproof the A8n (ac) series antenna ports.

Weatherproofing on A8n (ac) 2.4GHz Radio Antenna

Ports

1. Start wrapping a layer of electrical tape from 1/4” (6mm) above the

edge of the RF cable connector. Overlap the tape to half –width.

The tape should cover the RF cable connector body, and extend 1”

(25mm) above the cable connector clamping nut.

The tape can be applied in one or more strips if necessary. A strip

can be coiled onto an applicator such as a pencil. Apply only

enough tension to get good adhesion and keep the tape smooth.