User's Manual

Altai A8n (ac) Series Super WiFi Base Station

Installation Guide

Figure 29. Wrapping direction and extends the wrap 1” above the connector clamping

2. Start wrapping a layer of butyl rubber tape from the base of the A8n

(ac) series 5GHz antenna port. Overlap the tape to half –width.

Finish the wrap at 1” (25mm) above the electrical tape and cut the

tape. Take extra care to make sure that the RF cable connector to

A8n (ac) series 5GHz antenna port junction is tightly sealed. Press the

tape edges together so that there are no gaps. Press the tape

against the RF cable connector body and the A8n (ac) series 5GHz

antenna port.

3. If enhanced UV protection is required, start wrapping a layer of

electrical tape from the base of the A8n (ac) 2.4GHz antenna port.

Overlap the tape to half –width. Finish the wrap at 1” (25mm) above

the butyl rubber tape and cut the tape.

Weatherproofing A8n (ac) series 5GHz Antenna RF

Ports

1. Start wrapping a layer of electrical tape from 1/4” (6mm) above the

edge of the RF cable connector. Overlap the tape to half –width.

The tape should cover the RF cable connector body, and extend 1”

(25mm) above the cable connector clamping nut.

The tape can be applied in one or more strips if necessary. A strip

can be coiled onto an applicator such as a pencil. Apply only

enough tension to get good adhesion and keep the tape smooth.

2. Start wrapping a layer of butyl rubber tape 1” (25mm) below the

electrical tape. Overlap the tape to half –width. Finish the wrap at

the base of the antenna port and cut the tape. Take extra care to

make sure that the RF cable connector to A8n (ac) series 5GHz

Extend 1”

(25mm)