Installation Guide

Vanity Top Installation
1. Install cabinet per manufacturer’s instructions.
Note: Make sure cabinet is level before installing vanity top.
2. Clean underside of vanity sink with denatured alcohol.
Remove all dust and allow the surface dry completely.
Denatured
Alcohol
3. Apply a bead of adhesive or silicone onto each corner of
cabinet top.
4. Place Swanstone vanity top onto the cabinet, making sure
vanity is seated properly.
5. Wipe off any excess adhesive, and allow vanity top to set
for 24 hours to ensure maximum adhesion.
6. If desired, use a color-match silicone sealant (not
included). Place a bead of sealant along the seam of the
back splash panel and wall to create a moisture barrier.
WARNING
Solvents Hazard
Follow all manufacturers’
safety instructions for silicone
sealants and denatured alcohol. Alcohol vapors are both
flammable and hazardous to breathe. Silicone vapors may
irritate eyes and nose. Personal injury can result from
improperly handling or use of products, such as denatured
alcohol. Always follow the manufacturer’s
recommendations for the safe use of these products.
Ventilate any work area before beginning to apply silicone
sealants, cleaning agents, or solvents.
Installation Manual For Bathroom Vanity Top