Specifications

The remote mic kill switch carries out the function upon pressing it. This means that

the units (wired and wireless beltpacks, desk stations units, etc.) connected to the system

can switch ON the microphones again when required. When this switch is pressed, its

associated LED turns on during a short moment.

BUZZER

The Buzzer , produces a sound when a call is made, or a key is pressed. Through

internal presets you can set the buzzer sound level, high or low (factory default) and

configure if the buzzer is turned off when you enable remote buzzer kill (factory default) or

to work ever.

PA OUT SWITCH

The PA out switch allows to enable the PA output placed at the rear panel,

which normally is disabled, and to carry out the HEADSET/PANEL microphone signal to A

external audio systems.

Through internal presets, you can set the operating mode of the switch:

-Push to talk only or push to talk +latch mode (factory default)

-Send the program signal to the PA OUTPUT (disabled is factory default) and/or the

-Send the intercom line Channel A signal to the PA OUTPUT (disabled is factory default)

REMOTE BUZZER KILL SWITCH

This switch disables all the buzzers from all the intercom system channels (including

all beltpacks, desk station units and base station units). Local operators are not able to turn

on again its buzzers.

This button performs a rotating function. If it was enabled, pressing disabled it and the

associated LED turns off (at this time all external units can re-enable their local buzzers), on

the contrary, if it was disabled, pressing enabled it and the associated LED turn on (at this

time all the external units buzzers are disabled and can not re-enable it locally).

TALK SWITCH

The base station is provided with a talk switch per intercom channel. The TALK

switch allows to enable/disable the microphone, so that we are able to speak with other

units connected to the same intercom channel. If the channel A microphone is activated (for

example), and the channels B,C and D microphones are not activated, we will speak with

the stations connected to the channel A, but the connected stations to the channel B, C and

D won’t hear us.

If the microphone is activated, its associated LED will light up, and on the other hand, if

it is disabled, its associated LED will turn off.

EF-202/EF-204 MASTER STATION – E200 SERIES

9 9