Specifications

MEMORIES

The unit has four memories (PRESETS) that allow us to record and retrieve the

position of all the switches, so we can return to previously saved settings instantly. We can

also save the state of the call, so if when you record a memory, hold down the call switch

of the channel which we want to record an active call, when we recall the memory, the

system performs a call to the correspondent channel.

To record a memory, just hold the memory switch (PRESET) you want to record for

five seconds. The unit will beep and perform a twinkle in the LED light of the corresponding

preset switch, indicating that the memory is recorded.

To recall a previously recorded memory, simply short press the preset button that

you want to recall. If the status of the unit corresponds to one of the memories recorded, the

corresponding preset LED will remain lit.

Moreover, the base station saves the state of all switches, so retrieve the state it was

previously when it was turned off.

NOTE: In the preset memories are not recorded the internal adjustment settings, or the

program send setting to the intercom lines, or the program interrupt configuration.

PROGRAM INPUT, ON SWITCH

The program input on switch , injects the program signal to the configured intercom

lines. This intercom lines are configured easily by holding down the PRG ON key and then

selecting the desired channel TALK key. By default, the program is sent to all intercom

lines. For more details see chapter 6.

PROGRAM INPUT LEVEL CONTROL

The program input level control adjusts the signal level sent to the selected

channels. Next to the program input level control is marked the position in which the gain is

0, that is to say the same signal as in the input. Fully left the signal decreases in 10 dB and

totally to the right the signal increases in 20 dB.

Keep in mind that these gains are influenced by the position of the program input

MIC/LINE switch selector (placed at the rear panel). MIC position increases 30 dB gain.

PROGRAM TO HEADPHONES CONTROL

The program to headphones control allows to regulate the program signal level

that appears in the headsets connected to the base station unit and to the speaker .

EF-202/EF-204 MASTER STATION – E200 SERIES

2 22