Specifications

USB

PC connection (USB) is made via an USB A MALE / B MALE, allowing you to

control all functions of the base stations ALTAIR EF-202 and EF-204. The control software

can be downloaded after registration from the ALTAIR website (www.altairaudio.com), and

it attached the USB driver for the computer.

PROGRAM OUTPUT GAIN CONTROL

The program output gain control placed at the unit rear panel allows to regulate the

program signal level that appears in the XLR-3-32 male PA output connector placed at

the unit rear panel.

PROGRAM INPUT MIC/LINE LEVEL SELECTOR

The program input has a MIC/LINE level selector switch placed at the base station

rear panel.

With the switch pressed (MIC), the program input have an additional gain of 30 dB

allowing direct connection of balanced dynamic microphones.

INTERCOM LINE TERMINAL IMPEDANCE DIP SWITCHES

All the intercom lines should have a terminal impedance to make the different units

connected to them work correctly. When the unit is connected in Slave mode (connected to

a unit performing as Master unit) the terminal impedance is not longer needed and must be

removed. To ease the Z mode of the different channels, a dip switch is installed on the rear

of unit. In an intercom system, only a unit must be configured as Master.

EF-202/EF-204 MASTER STATION – E200 SERIES