Specifications

6. INTERNAL CONFIGURATION SETTINGS

SETTING THE PROGRAM INPUT SEND AND THE PROGRAM INTERRUPT

The program input send, and the program interruption (program send to the line is

interrupt while the microphone (TALK) corresponding to this line is active) can be

configured as follows:

 Hold down the program input switch , for five seconds. At that time the unit will

beep and will start blinking the program input LED .

 If the program send is enabled, the corresponding TALK LED will remain blinking,

otherwise, stay off.

 To enable/disable the program send to a specific line, press the TALK switch of

the corresponding line.

 If the program interrupt of a specific line is enabled, the corresponding LISTEN LED

will remain blinking, otherwise it will remain off.

 To enable/disable the program interrupt of a specific line, press the LISTEN switch

of the corresponding line.

 If you press again the program input switch , or if you wait for a few seconds

without pressing any key, the setting of the program send and program interrupt will

be aborted and the base station will return to normal operation.

NOTE: The base stations are factory configured, with the program send enabled to all lines,

and the program interrupt of all lines disabled.

EF-202/EF-204 MASTER STATION – E200 SERIES