Specifications

The internal parameters of the base station can be configured as follows:

 Hold down the speaker switch , for five seconds. At that time the unit will beep and

will start blinking the speaker LED .

 If the parameter is enabled, the corresponding LED will remain blinking, otherwise,

stay off.

 To enable/disable the program send to a specific line, press the corresponding

switch.

 If you press again the speaker switch , or if you wait for a few seconds without

pressing any key, the internal configuration setting will be aborted and the base

station will return to normal operation.

 To clear the internal memory, the presets and the working memory (back to the base

station factory default), hold the speaker switch for ten seconds.

PANEL MIC KEY MODE

SWITCH → PANEL MIC .

LED BLINKING → Push to talk mode, the PANEL MIC switch don't have

latch mode.

LED OFF → Latch in short time presses of the switch and push to talk

in long presses of the switch. Factory default.

PA OUT KEY MODE

SWITCH → PA out .

LED BLINKING → Push to talk mode, the PA out switch don't have

latch mode.

LED OFF → Latch in short time presses of the switch and push to talk

in long presses of the switch. Factory default.

EXTERNAL MIC KILL & BUZZER KILL

SWITCH → MIC KILL .

LED BLINKING → The external mic kill and buzzer kill signal turn off the

base station mic and the buzzer respectively.

LED OFF → The external mic kill and buzzer kill signal, don't turn off

the base station mic and the buzzer respectively. Factory

default.

EF-202/EF-204 MASTER STATION - SERIE E-200