Troubleshooting guide

If we pressed key REGISTER again the function will be reset.

The beltpack registration can be made through the menu, in witch we select the

base station that we want to register the beltpack (FIRST or SECOND), or with the

beltpack that we want to register turned off, turn on pressing the ON/OFF

switch maintaining pressed the VOLUME UP/DOWN switches (to register it the

FIRST base station) or maintaining pressed the VOLUME UP/DOWN and the

SELECT (BUZZER) switches (to register it the SECOND base station).

If you press the MENU (ESCAPE) switch, the register procedure will be

cancelled.

If everything goes well, the base station base will sound (if

the buzzer it is turned on) and the beltpack also (if the buzzer it

is turned on), the corresponding base station IN RANGE led will

turn on and the ON/OFF switch LED of the wireless beltpack start

blinking, the base station range indicator on the

display will stop blinking, indicating the range level.

If the procedure fails, turn off the base station and the beltpack and start again.

Registering process must be near the base station and is not allowed during battery

charging.

3.6.15 BELTPACK DEREGISTRATION

Turn on the base station that you want to deregister the

wireless beltpack.

The beltpack deregister can be made through the menu,

and with the wireless beltpack connected to the base station on

which you want to delete the registration, the beltpack ask if you're sure to delete the register,

and once confirmed the register will be deleted immediately, or turning on the beltpack pressing

the ON/OFF switch maintaining pressed the MENU and the SELECT switches, the beltpack will

start normally, but when it is connected to the base station, this one will be reset and the

beltpack will be deregistered. We can cancel the deregistration procedure, before the

wireless beltpack connect with the base station, by pressing the MENU (ESCAPE) switch.

If the procedure fails, turn off the base station and the beltpack and start again.

3.7 ON/OFF SWITCH

When the beltpack is power off, and the beltpack’s ON/OFF switch it is pressed and

hold for two seconds, all the beltpack LEDs light on and last a little while it will sound

the buzzer (if buzzer is turn on) and will vibrate (if the vibrator is turn on), and the display

will turn on, indicating that it is operative.

If the base on which it is registered finds within its range, the ON/OFF switch LED will begin to

blink, the base station range indicator in the display will stop to blink and the audio will be

opened. At this moment you can begin to use your ALTAIR WBP-210 wireless beltpack.

To turn off the beltpack, press and hold two seconds the ON/OFF switch when the beltpack is

turned on. In this moment will sound the buzzer (if the buzzer is turn on), a

GOODBYE message appears in the display and when the ON/OFF switch

it is depressed, the beltpack it is turned off.

If the wireless beltpack is turned on, and you press the ON/

OFF button for a while, the beltpack shows the battery status.

WBP-210 SINGLE CHANNEL WIRELESS BELTPACK