WBP-212 WIRELESS DUAL CHANNEL MANAGER BELTPACK WB-200 SERIES WIRELESS INTERCOM SYSTEM OWNERS MANUAL ISSUE 29J10 AUDIO ELECTRONICS DESIGN EQUIPOS EUROPEOS ELECTRÓNICOS, S.A.L Avda. de la Industria, 50. 28760 TRES CANTOS-MADRID (SPAIN). 34-91-761 65 80 34-91-804 43 58 www.altairaudio.com altair@altairaudio.
WBP-212 WIRELESS DUAL CHANNEL MANAGER BELTPACK 2 1. INTRODUCTION.........................................................................................................................................3 2. SWITCHES, CONTROLS, ADJUSTMENTS AND CONNECTORS....................................................................4 2.1 UPPER PANEL..........................................................................................................................................................4 2.2 FRONT PANEL..
WBP-212 WIRELESS DUAL CHANNEL MANAGER BELTPACK 3 1. INTRODUCTION Congratulations on your purchase of the ALTAIR single channel wireless beltpack WBP-212 of the WB-200 series wireless intercom system. There are a lot the characteristics that make of the ALTAIR WB-200 series one of the most highlighted in the audio professional market, some are enumerated here: Dual channel Manager beltpack allowing simultaneous or private conversation with 2 different wireless or wired intercom channels.
WBP-212 WIRELESS DUAL CHANNEL MANAGER BELTPACK 4 2. SWITCHES, CONTROLS, ADJUSTMENTS AND CONNECTORS Switches, controls, adjustments and connectors that you can find in your ALTAIR intercom beltpack. The description and explanation of each one will be found in the corresponding section. 2.1 UPPER PANEL - MIC SWITCH. - CHANNEL SELECT / STAGE ANOUNCE SWITCH 2.2 FRONT PANEL - CALL SWITCH. - OLED DISPLAY. - MENU SWITCH. - SELECT SWITCH. - ON/OFF SWITCH. - VOLUME UP/DOWN SWITCHES. 2.
WBP-212 WIRELESS DUAL CHANNEL MANAGER BELTPACK 5 3. OPERATION The WB-200 series intercom system are designed to allow maximum easy communications operation between the different control areas in music or theatre live performances, television, cinema, conference halls, and whatever broad events where multiple and fast communications are required, by means of its simultaneous listening-speaking operation system.
WBP-212 WIRELESS DUAL CHANNEL MANAGER BELTPACK 6 NOTE: Headphones could be with a double or single muff. In case of using a double muff headphone, the two speakers should be wired in parallel mode. 3.2 MIC ON/OFF/PUSH TO TALK SWITCH (TALK) The MIC switch allows to enable/disable the microphone, so that we are able to speak with other units connected to the same intercom channel.
WBP-212 WIRELESS DUAL CHANNEL MANAGER BELTPACK 7 Press and hold the Channel Select switch and when the AB lamps flashes (wait 2 seconds), start your message from the headset microphone. When done, release the switch. On the WBS-202 base station, the front panel SA led will glow for the time you are depressing this switch and the message is carried out from the SA output to the external PA equipment. This function is very useful for timing events, fire alarms, or general announces.
WBP-212 WIRELESS DUAL CHANNEL MANAGER BELTPACK 8 3.7 MENU SWITCH When the MENU switch is pressed and there isn't active any message on the wireless beltpack, appears the menu of the beltpack, with which various parameters of the beltpack can be configured. If any beltpack message or the beltpack menu are active, the system return to normal mode.
WBP-212 WIRELESS DUAL CHANNEL MANAGER BELTPACK 9 3.7.4 SIDETONE GAIN ADJUSTMENT The sidetone gain adjustment allows attenuating or amplifying the own mic signal that we listen in our headphones. The sidetone gain can be adjust with the appropriate menu, or directly without accessing the beltpack menu, pressing the SELECT (BUZZER) switch and at the same time the VOLUME switches (UP to increase the gain or DOWN to decrease the gain). The SIDETONE GAIN, it is stored in the unit.
WBP-212 WIRELESS DUAL CHANNEL MANAGER BELTPACK 10 3.7.8 CHANGING THE BELTPACK NAME With the Name MENU, the user can change the beltpack name that appears on the display , under the beltpack registration number, this name has 7 characters, selected by the user.
WBP-212 WIRELESS DUAL CHANNEL MANAGER BELTPACK 11 3.7.12 KEYBOARD LOCK The keyboard lock is useful to prevent unwanted use and to avoid unwanted key press. With this menu option you can lock the keys configured in the keyboard lock configuration (see section 3.7.11) TOP Panel, FRONT panel or all.
WBP-212 WIRELESS DUAL CHANNEL MANAGER BELTPACK 12 able to be registered until the deregistration of some beltpack is made or deregister all the beltpacks registered in the base station (consult the base station WBS-200 manual for more information). If we do not do anything during 60 seconds the function will be reset. If we pressed key REGISTER again the function will be reset.
WBP-212 WIRELESS DUAL CHANNEL MANAGER BELTPACK 13 If the wireless beltpack is turned on, and you press the ON/ OFF button for a while, the beltpack shows the battery status. 3.9 VOLUME UP/DOWN SWITCHES The volume switches allows attenuating or amplifying the signal sent to the headphones. This switches adjusts the listen level to the headphones as you wish. When volume UP/DOWN switches are pressed, appears in the volume level indication allow us change this volume level.
WBP-212 WIRELESS DUAL CHANNEL MANAGER BELTPACK 14 4. SPECIAL OPERATIONS In order to set-up some of the wireless beltpack possibilities, the unit must be opened removing the bottom auxiliary cover, removing a screw. NOTE: This type of operations takes place with the unit is opened; the best thing should be to carry it out by a qualified technician. Care must be taken to avoid short circuit between battery holders, etc. DANGER: Before opening the unit, turn it off.
WBP-212 WIRELESS DUAL CHANNEL MANAGER BELTPACK 15 6. TROUBLESHOOTING GUIDE WHEN: 1) Abnormal low range. POSSIBLE CAUSES AND SOLUTIONS a) With the beltpacks on, switch off the base station, wait for 30 seconds and then switch on to reorganize links. 2) Beltpack switch on but does a) Beltpack is not registered. If the base station have free registers, register it not link with the base station. normally. b) If you have more than a system it is possible that this beltpack correspond to another system.
WBP-212 WIRELESS DUAL CHANNEL MANAGER BELTPACK 16 7. BATTERY CHARGER ALTAIR WBPC-210 The battery charger ALTAIR WBPC-210 allows to charge up to four beltpacks ALTAIR WBP-210/WBP-212 simultaneously. The charge time is approximately of four hours with the batteries totally discharged. 7.1 CHANGING THE FUSE The battery charger ALTAIR WBPC-200 is set to operate from 100 VAC, 50-60Hz to 240VAC, 50-60Hz. Make sure that the unit is disconnected of the mains.
WBP-212 WIRELESS DUAL CHANNEL MANAGER BELTPACK 17 7.3 BELTPACK BATTERY CHARGE The battery charger ALTAIR WBPC-210 has four connectors to allow the charge up to four wireless beltpacks at the same time. Take any of the battery charger connector and insert it in a wireless beltpack connector. If the battery charger is connected, the connector associated LED of the battery charger will change from green to orange, indicating that the wireless beltpack batteries are charging.
WBP-212 WIRELESS DUAL CHANNEL MANAGER BELTPACK 18 8. TECHNICAL SPECIFICATIONS PREAMPLIFIER MICROPHONE TYPE: INPUT IMPEDANCE: NOMINAL LEVEL: PHANTOM VOLTAGE: • • • • Dynamic or electret. 4K7. -45 dBu. +9 VDC (internal preset ). 200 Ω (nominal), 2KΩ (maximum). OUTPUT POWER: • • • FREQUENCY RESPONSE: • HEADSET AMPLIFIER IMPEDANCE: MAXIMUM LEVEL: 14 Vpp (200 Ω). 200 mW (200 Ω). 250 Hz - 3500 Hz. RADIO FREQUENCY: MODULATION: TRANSMIT POWER: RECEIVE SENSITIVITY: • 1900 MHz band.
WBP-212 WIRELESS DUAL CHANNEL MANAGER BELTPACK 19 9. WARRANTY This unit is warranted by Equipos Europeos Electrónicos to the original user, against flaws in the manufacturing and in the materials, for a period of two years (one year depending on some countries), starting from the date of sale. Flaws due to wrong use of the unit, internal modifications or accidents, are not covered by this warranty. There is no other warranty expressed or implicit.
WBP-212 WIRELESS DUAL CHANNEL MANAGER BELTPACK 20 European Union Waste Electronics Information Unión Europea Información sobre residuos electrónicos Waste from Electrical and Electronic Equipment (WEEE) directive The WEEE logo signifies specific recycling programs and procedures for electronic products in countries of the European Union. We encourage the recycling of our products. If you have further questions about recycling, contact your local sales office.
