Troubleshooting guide

11
3.7.12 KEYBOARD LOCK
The keyboard lock is useful to prevent unwanted use
and to avoid unwanted key press. With this menu option you
can lock the keys configured in the keyboard lock
configuration (see section 3.7.11) TOP Panel, FRONT panel or
all.
The keyboard lock can be enabled via the appropriate menu, or directly without accessing
the beltpack menu, pressing the ON/OFF switch, and at the same time the MIC ON/OFF
switch (changing the vibrator state, if it is on, turn to off mode and if the vibrator
it is turned off, turn to on mode). It can only be disable by pressing the
ON/OFF switch, and at the same time the MIC ON/OFF switch unless the keyboard lock
configuration will be only the TOP panel keys, in which case it can be disabled by menu.
Whenever the keyboard will be locked, the following icon appears on the display: .
3.7.14 STAND BY MODE
In this mode, the beltpack can receive CALLs, but the audio it
is disconnected. This mode is useful to save battery, since the
beltpack consumes 5 times less than in full duplex state.
at the same time
switch.
switch briefly.
3.7.15 BELTPACK REGISTRATION
Each beltpack can be registered in two different base stations,
so that if it loses the range of one, changes the operation to the other
base station. Each base station can register a maximum of four
beltpacks. See the WBS-200 owners manual for details.
With the base station turned on, press and hold the REGISTER base station switch during six
seconds. At this moment the base station will sound (if the
buzzer is turned on) and will blink the IN-RANGE (1-2-3-4) leds
corresponding where is going away to register the new
beltpack. If the base station has registered four beltpacks
already, the function will be reset, and new beltpacks will not be
WBP-212 WIRELESS DUAL CHANNEL MANAGER BELTPACK