Troubleshooting guide

12
able to be registered until the deregistration of some beltpack is made or deregister all the
beltpacks registered in the base station (consult the base station WBS-200 manual for more
information).
If we do not do anything during 60 seconds the function will be reset.
If we pressed key REGISTER again the function will be reset.
The beltpack registration can be made through the menu, in witch we select the base
station that we want to register the beltpack (FIRST or SECOND), or with the beltpack that we want
to register turned off, turn on pressing the ON/OFF switch maintaining pressed the
VOLUME UP/DOWN switches (to register it the FIRST base station) or
maintaining pressed the VOLUME UP/DOWN and the SELECT (BUZZER)
switches (to register it the SECOND base station).
If you press the MENU (ESCAPE) switch, the register procedure will be
cancelled.
If everything goes well, the base station base
will sound (if the buzzer it is turned on) and the beltpack also (if
the buzzer it is turned on), the corresponding base station IN
RANGE led will turn on and the ON/OFF switch LED of the
wireless beltpack start blinking, the base station range indicator
on the display will stop blinking , indicating the range
level.
If the procedure fails, turn off the base station and the beltpack and start again.
Registering process must be near the base station and is not allowed during battery
charging.
3.7.16 BELTPACK DEREGISTRATION
Turn on the base station that you want to deregister the
wireless beltpack.
The beltpack deregister can be made through the menu,
and with the wireless beltpack connected to the base station on
which you want to delete the registration, the beltpack ask if you're sure to delete the register,
and once confirmed the register will be deleted immediately, or turning on the beltpack pressing
the ON/OFF switch maintaining pressed the MENU and the SELECT switches,
the beltpack will start normally, but when it is connected to the
base station, this one will be reset and the beltpack will be deregistered. We can
cancel the deregistration procedure, before the wireless beltpack connect with the base station,
by pressing the MENU (ESCAPE) switch.
If the procedure fails, turn off the base station and the beltpack and start again.
3.8 ON/OFF SWITCH
When the beltpack is power off, and the beltpack’s ON/OFF switch it is pressed and
hold for two seconds, all the beltpack LEDs light on and last a little while it will sound
the buzzer (if buzzer is turn on) and will vibrate (if the vibrator is turn on), and the display
will turn on, indicating that it is operative.
If the base on which it is registered finds within its range, the ON/OFF switch LED will begin to
blink, the base station range indicator in the display will stop to blink and the audio will be
opened. At this moment you can begin to use your ALTAIR WBP-212 wireless beltpack.
To turn off the beltpack, press and hold two seconds the ON/OFF switch when the beltpack is
turned on. In this moment will sound the buzzer (if the buzzer is turn on), a
GOODBYE message appears in the display and when the ON/OFF switch
it is depressed, the beltpack it is turned off.
WBP-212 WIRELESS DUAL CHANNEL MANAGER BELTPACK