- ALTEC LANSING inMotion USER GUIDE IM600

5
The
rechargeable
battery
won’t
charge and
no power
indicator
light is
on (AC
operation).
No Power
indicator
light is on
(Battery
operation).
No sound is
coming from
speakers.
The surge protector (if used) isn’t
powered on.
The wall outlet is not functioning.
The power isn’t turned on.
The rechargeable battery isn’t
charged.
The power isn’t turned on.
The volume is set too low.
An incorrect source has been selected.
The iPod is not correctly seated into
the docking station.
If using an alternate audio source, the
audio source is not properly connected
to the inMotion iM600 or there is a
problem with the alternate audio
source.
If the power supply cord is plugged into a surge
protector, make sure the surge protector is switched on.
Plug another device into the same wall outlet to
confirm the outlet is working.
Turn on the inMotion iM600 by pushing the button.
The indicator light turns on.
Recharge the battery (see the “Power” section for
details.)
Turn on the inMotion iM600 by pushing the button.
The indicator light turns on.
The “+” and “–” buttons control the master volume.
Press and hold the “+” button to increase the volume.
Check the volume level on alternate audio source
device and set at mid-level.
Press the SOURCE button until the appropriate source
is displayed on the LCD screen.
Turn off the iPod, remove it from the docking station,
reseat it, and turn it on again.
• Connect an alternate audio source—such as a CD
player, MP3 player, or portable DVD player—to your
inMotion iM600 by plugging one end of a 3.5mm
stereo cable (sold separately) to the line out of your
portable device (if it has one) or to the device’s
headphone jack. Connect the other end to the input
marked “AUX” on the back of the inMotion iM600.
• Set the volume on the audio source at mid-level.
• Set the volume on the inMotion iM600 at minimum
level and adjust upward to a comfortable listening
level.
Troubleshooting
Symptom Possible Problem Solution