Operation Manual

4
Getting Started
How to Install the Backup Battery
This Altec Lansing Moondance Glow speaker system uses a backup battery
system to provide continuous clock settings in the event of a power failure.
Withthebackupbattery(notincluded)installed,ifapowerfailureoccurs
ortheACcordisaccidentallydisconnected,thedisplaywillnotremain
lit and the alarm will not function, but the current time will be temporarily
maintained.Otherwise,youmustresetthetimeandalarmsettings.
1 Make sure the AC adapter is
connected.
Your settings may be lost during
batteryinstallationiftheACadapter
isn’t connected.
2 Open the battery compartment
cover.
The compartment cover is located on
the bottom of the system.
3 Insert one 9-volt battery (not included).
Besuretocheckthatthepolarity(+and–endsofthebatteries)
matches the illustration inside the battery compartment. Altec Lansing
recommends the use of alkaline batteries for longer life.
4 Close the battery compartment cover.
How to Install the AC Adapter
1 Connect the AC adapter cable plug
into the speaker system’s jack.
Thejackislocatedonthebackofthe
system.
2 Plug the AC adapter into the wall
outlet.
How to Install the Enhanced Remote
Battery
Theenhancedremotebattery(included)is
not installed at the factory. To install the battery, follow the steps below:
1 Pull out the battery holder.
The battery door is located on the
lowerendoftheremote.Simplypull
the tab to open the battery holder.
2 Position the battery (included) so it
sits in the battery holder correctly.
Makesurethepolarity(the+and–sidesofthebattery)iscorrect.
3 Replace the battery door.
NOTE Please discard used batteries properly.