User's Manual Part 1

4
Getting Started
How to Install the Backup Battery
This Altec Lansing FPO NAME speaker system uses a backup battery
system to provide continuous clock settings in the event of a power failure.
Withthebackupbattery(notincluded)installed,ifapowerfailureoccurs
or the AC cord is accidentally disconnected, the display will not remain
lit and the alarm will not function, but the current time will be temporarily
maintained. Otherwise, you must reset the time and alarm settings.
1 Make sure the AC adapter is
connected.
Your settings may be lost during
battery installation if the AC adapter
isn’t connected.
2 Open the battery compartment
cover.
The compartment cover is located on
the bottom of the system.
3 Insert one 9-volt battery (not included).
Besuretocheckthatthepolarity(+and–endsofthebatteries)
matches the illustration inside the battery compartment. Altec Lansing
recommends the use of alkaline batteries for longer life.
4 Close the battery compartment cover.
How to Install the AC Adapter
1 Connect the AC adapter cable plug
into the speaker system’s jack.
The jack is located on the back of the
system.
2 Plug the AC adapter into the wall
outlet.
How to Install the Enhanced Remote
Battery
Theenhancedremotebattery(included)is
not installed at the factory. To install the battery, follow the steps below:
1 Pull out the battery holder.
The battery door is located on the
lower end of the remote. Simply pull
the tab to open the battery holder.
2 Position the battery (included) so it
sits in the battery holder correctly.
Makesurethepolarity(the+and–sidesofthebattery)iscorrect.
3 Replace the battery door.
NOTE Please discard used batteries properly.
ANTENNA
SNOOZE
REMOTE
CLOCK
AU X
DC
SNOOZE
REMOTE
ANTENNA
FM
CLOCK
AUX
DC