Operation Manual

9
EN
1 Dock your iPhone or iPod in the
Altec Lansing Octiv650 speaker
system.
2 Turn on your speaker system.
3 Find your desired song or video.
4 Start playing your song or video.
5 Adjust the volume.
NOTE Whenever your iPhone or iPod is
docked, it is charging until fully charged.
How to Output Video to an External
Monitor or TV
The “VIDEO” button on the speaker system allows the user to change its
video output mode. There are three available modes:
• Off: Video pass through disabled, indicated by 1 LED when the
video button is pressed. Video will play on the iPhone or iPod
screen only.
• Composite: Indicated by 2 LEDS when the video button is
pressed. Video will play on an external composite video monitor,
if connected. Connect a single RCA cable from the blue RCA jack
labeled “COMP Pb & CVBS OUT” on the back of the speaker to the
composite input jack (yellow RCA) on your monitor or television.
• Component: Indicated by 3 LEDS when the video button is
pressed. Video will play on an external component RGB video
monitor, if connected. Connect the blue, green, and red RCA
outputs labeled “COMP Pb & CVBS OUT,” “COMP Y OUT” and
“COMP Pr OUT” on the back of the speaker to the respective color
inputs on your monitor or television with a 3-connector RCA cable.
Press the “VIDEO” button to cycle through settings: Component, Off and
Composite. The video output mode is set to Component by default at the
factory.
How to Connect a Newer iPhone or iPod touch
On newer iPhone and iPod touch devices that use the iOS operating
system, you need to configure the speaker system to tell the iPhone or
iPod what type of video output you are using. Pressing the “VIDEO” button
cycles through “Component,” “Off” and “Composite” video output modes,
in that order. The factory default setting is “Component.”
1 Ensure your cable connections from the speaker system to
your monitor or TV are correct for your desired output mode.
2 Configure the speaker system for your desired output mode:
For component video playback, you don’t have to do anything. The
Octiv650 speaker system is set to “Component” at the factory. For
composite playback, press the “VIDEO” button twice (assuming the
speaker system is in “Component” mode) to set the speaker system
to “Composite” mode.
3 If video does not automatically start playing on your TV or
external monitor, press play again on your device.
NOTE When the speaker system external video mode is set to “Off,” video
will play back on your iPhone or iPod touch only.
How to Listen to Your iPhone or iPod