Moondance Home Digital Speaker System and Alarm Clock for iPod User Guide

12
1 Plug the FM radio antenna into the speaker system’s FM
ANTENNA jack.
The jack is located on the back of the system.
2 Extend the FM antenna wire fully for best FM reception. Also,
do not strip, alter or attach to other antennas.
3 Ensure your speaker system is powered on.
If the system isn’t on, press the STANDBY button on the speaker
system or the
button on the wireless remote.
4 Select “FM” mode.
PresstheSOURCEbuttononyourspeakersystemortheSOURCE
buttononthewirelessremoteuntiltheFMappearsontheLCD.
5 Tune to the station you want to listen to.
Use the
and buttons on the wireless remote to tune in the
desired station.
Pressandholdthesesamebuttonsfor3secondstondthenext
clearFMstation.PressandholdtheAUTObuttononthewireless
remotefor3secondstoautomaticallytuneandsaveallclearFM
stations.
6 Adjust the volume.
UsetheVOLUME+and–VOLUMEbuttonsontheAltecLansing
MoondanceHomespeakersystemtoadjustthesystemvolume.Or,
usetheVOLUME+and–VOLUMEbuttonsonthewirelessremote.
NOTE ExtendtheFMantennawirefullyforbestFMreception.Also,donot
strip, alter or attach to other antennas.
How to Store Preset Stations
Your Altec Lansing Moondance Home speaker system’s wireless remote
enablesyoutoprogramupto16FMstationpresets:
1 Ensure your speaker system is powered on.
2 Make sure you are in “FM” mode.
3 Tune to the station you wish to store.
4 Store the station.
PresstheENTERbuttononthewirelessremote.Apresetlocation
will show and begin to flash. The station stored in that preset will be
displayed in the lower right-hand corner of the LCD display.
UsetheVOLUME+and–VOLUMEbuttonsonthewirelessremote
to select the preset location you want to store the station in.
PresstheENTERbuttontostorethestationinthepresetlocation.
YoucanstoreoneFMstationineachpresetlocation.
5 To store other preset stations, repeat the above steps.
How to Recall Preset Stations
1 Ensure your speaker system is powered on.
2 Make sure you are in “FM” mode.
3 Use the and buttons on the wireless remote to select
the desired preset.
The radio will tune to your preset station.
4 Adjust the volume.
Listening to the FM Radio