Moondance Home Digital Speaker System and Alarm Clock for iPod User Guide

13
Listening to a Non-docking iPod or Other Portable Audio Device
Ifyouhaveanon-iPodMP3playerorothernon-dockingportableaudio
device, you can enjoy it through your Altec Lansing Moondance Home
speakersystemaswell.JustconnectitviatheAUXINjack.Here’show:
1 Locate a 3.5 mm stereo cable
(not included).
2 Plug one end of the stereo cable
into your device.
Your device should have either a
headphoneorLINEOUTjackforyou
to plug into.
3 Plug the other end of the stereo
cable into your speaker system’s
AUX IN jack.
TheAUXINjackislocatedonthebackoftheunit.
4 Ensure your speaker system is powered on.
If the system isn’t on, press the STANDBY button on the speaker
system or the
button on the wireless remote.
5 Select “AUX” mode.
PresstheSOURCEbuttononyourspeakersystemortheSOURCE
buttononthewirelessremoteuntiltheAUXappearsontheLCD.
6 Turn on your device and start it playing.
7 Adjust the volume.
UsetheVOLUME+and–VOLUMEbuttonsontheAltecLansing
MoondanceHomespeakersystemtoadjustthesystemvolume.Or,
usetheVOLUME+and–VOLUMEbuttonsonthewirelessremote.
NOTE You may need to adjust the device volume also. Your device’s
volume should be set to approximately ¾ volume.
8 When you are finished listening to your portable audio device,
please remember to turn both it and your speaker system off
to conserve electricity.