Moondance Home Digital Speaker System and Alarm Clock for iPod User Guide

8 Exit the Alarm Set mode.

PresstheALARM1buttononthespeakersystemortheENTER

button on the wireless remote to exit the Alarm Set mode. The

speaker system will also automatically exit the Alarm Set mode after

5secondsofinactivity.

NOTE When exiting the Alarm Set mode, the alarm is automatically turned

on.Toturnoffthealarm,pressthecorrespondingALARM1/ALARM2button.

NOTE The alarm time is displayed in the lower right-hand corner of the LCD

display when you turn the alarm on. If both alarms are active, the time for

Alarm1willbedisplayedinthelowerright-handcorner.

NOTE Ifbothalarmsareactiveatoverlappingtimes,Alarm1takes

precedenceoverAlarm2.

NOTE This Altec Lansing Moondance Home speaker system features

a built-in backup battery system to provide continuous clock settings in

the event of a power failure. If a power failure occurs or the AC cord is

accidentally disconnected, the display will not remain lit and the alarm will

not function, but the current time will be maintained.

NOTE If “iPod” is selected as the alarm source but no iPod is docked when

thealarmgoesoff,thebuzzeralarmwillsoundinstead.

NOTE IftheiPod,FMradioorAUXINisplayingwhenthealarmgoesoff

and a different alarm source has been selected, the speaker system will

switch to the selected alarm source.

How to Set Alarm 2

Repeattheabovesteps,substituting“Alarm2”for“Alarm1.”

How to Use Alarm 1

1 Press the ALARM1 button on either the speaker system or the

wireless remote.

Thisactivatesthealarm.TheAlarm1iconintheupperleft-hand

corner of the LCD display will light and the alarm time will display in

the lower right-hand corner of the display.

2 When the clock times matches the alarm time, the alarm

sounds, the Alarm 1 icon ﬂashes, and the whole display

ﬂashes.

The alarm gets progressively louder until it reaches the set level. After

atotalof59minutes,thealarmwillsilenceitself.

3 To dismiss the alarm, press the ALARM1 or ALARM2 buttons

on the speaker system or the ALARM1 or ALARM2 buttons on

the wireless remote.

4 To disable the alarm before its time is up, press the Alarm1

button.

How to Use Alarm 2

Repeattheabovesteps,substituting“Alarm2”for“Alarm1.”

How to Use the Snooze Feature

PresstheSNOOZEbuttononcetosilencethealarmforaperiodof

5minutes.

Setting the Alarm