Moondance Home Digital Speaker System and Alarm Clock for iPod User Guide

19
Troubleshooting
Symptom Possible Problem Solution
iPod didn’t charge
iPod is not installed properly RemoveyouriPodfromthedockandcheckforobstructionsonthe
connectors in the dock and on your iPod. Then reseat it in the dock.
iPod is locked up Please make sure your iPod is working properly before docking into the unit.
Please refer to your iPod manual for details.
AC adapter isn’t plugged into a wall outlet,
or the connector is not plugged into the
power supply jack on the back of the
speaker system
Plug the AC adapter into a wall outlet and plug the connector into the supply
jack on the speaker system.
Sound is distorted
Volume level is set too high Decrease the volume.
Sound source is distorted IftheiPodoriginalsoundsource(MP3)isofpoorquality,distortionandnoise
are easily noticed with high-power speakers. Try a different audio source such
as a music CD.
Wireless remote doesn’t work
Battery is weak Replacecurrentbatterywithanewbattery.
Wireless remote is not pointed toward the
speaker system
Point the wireless remote toward the Altec Lansing speaker system and move
within10feetoftheunit.
NosoundfromtheAUX
IN device, such as an
MP3playerorCDplayer
connectedtotheAUXINjack
Volume on the device is set too low Increase the volume on the device to approximately ¾ full volume.
SourceselectorisnotsettoAuxOut SetsourceselectortoAuxOut.