User manual

Starting simple with the D/A
A simple test is to run a counter and send the count values to the D/A
and observe the waveform. About as basic test you can do.
Check the schematic and data sheet to
▶
determine the part number.
▶
see how the part is designed into the board.
▶
find the PMod pin signal assignments.
Check the D/A data manual to determine
▶
how it works. Actually, to learn how to make it work.
▶
the signal timings.
▶
the mapping from digital input values to output voltages.
EECS 452 – Fall 2014 Lecture 5 – Page 133/143 Tuesday – September 16, 2014