User manual

DE2 User Manual
67
Figure 5.13. Block diagram of the Music Synthesizer design
Demonstration Setup, File Locations, and Instructions
• Project directory: DE2_Synthesizer
• Bit stream used: DE2_Synthesizer.sof or DE2_Synthesizer.pof
• Connect a PS/2 Keyboard to the DE2 board.
• Connect the VGA output of the DE2 board to a VGA monitor (both LCD and CRT type of
monitors should work)
• Connect the Lineout of the DE2 board to a speaker.
• Load the bit stream into FPGA.
• Make sure all the switches (SW[9:0]) are set to 0 (Down Position)
• Press KEY1 on the DE2 board to start the music demo
• Press KEY0 on the DE2 board to reset the circuit
Table 5.1 and 5.2 illustrate the usage of the switches, pushbuttons (KEYs), PS/2 Keyboard.