User guide

Info–8 Additional InformationAdditional Information
Revision History
Altera Transceiver PHY IP Core March 2012 Altera Corporation
User Guide
All Chapters
December
2010
1.11
■ Corrected frequency range for the phy_mgmt_clk for the Custom PHY IP core in Table 7–20
on page 7–21.
■ Added optional reconfig_from_xcvr[67:0] to Figure 4–4 on page 4–12. Provided more
detail on size of
reconfig_from_xcvr in Table 4–18 on page 4–23
■ Removed table providing ordering codes for the Interlaken PHY IP core. Ordering codes are
not required for Stratix V devices using the hard implementation of the Interlaken PHY.
■ Added note to 10GBASE-R release information table stating that “No ordering codes or
license files are required for Stratix V devices.”
■ Minor update to the steps to reconfigure a TX or RX PMA setting in the Transceiver
Reconfiguration Controller chapter.
Introduction
December
2010
1.1
■ Revised reset diagram.
■ Added block diagram for reset
■ Removed support for SOPC Builder
Getting Started
December
2010
1.1
■ Removed description of SOPC Builder design flow. SOPC Builder is not supported in this
release.
10GBASE-R PHY Transceiver
December
2010
1.1
■ Added Stratix V support
■ Changed phy_mgmt_address from 16 to 9 bits.
■ Renamed management interface, adding phy_ prefix
■ Renamed block_lock and hi_ber signals rx_block_lock and rx_hi_ber , respectively.
■ Added top-level signals for external PMA and reconfiguration controller in Stratix IV devices.
Refer to Table 3–18 on page 3–20.
■ Removed the mgmt_burstcount signal.
■ Changed register map to show word addresses instead of a byte offset from a base address.
XAUI PHY Transceiver
December
2010
1.1
■ Added support for Arria II GX and Cyclone IV GX with hard PCS
■ Renamed management interface, adding phy_ prefix
■ Changed phy_mgmt_address from 16 to 9 bits.
■ Renamed many signals. Refer to “XAUI Top-Level Signals—Soft PCS and PMA” on
page 4–12 and “XAUI Top-Level Signals–Hard IP PCS and PMA” on page 4–11 as
appropriate.
■ Changed register map to show word addresses instead of a byte offset from a base address.
■ Removed the rx_ctrldetect and rx_freqlocked signals.
Date Version Changes Made SPR