User guide

Native PHY IP Parameter Settings for Basic (Enhanced PCS) and Basic with KR FEC
Table 2-174: General and Datapath Parameters
The first two sections of the Parameter Editor for the Transceiver Native PHY provide a list of general and
datapath options to customize the transceiver.
Parameter Range
Message level for rule violations error, warning
Transceiver configuration rules Basic (Enhanced PCS), Basic w/KR FEC
PMA configuration rules Basic, QPI, GPON
Transceiver mode TX / RX Duplex, TX Simplex, RX Simplex
Number of data channels 1 to 96
Data rate GX transceiver channel: 960 Mbps
(41)
to 17.4 Gbps
GT transceiver channel: 17.4 Gbps to 28.3 Gbps
(42)
Enable datapath and interface reconfi‐
guration
On / Off
Enable simplified data interface On / Off
Table 2-175: TX PMA Parameters
Parameter Range
TX channel bonding mode Not bonded, PMA only bonding, PMA and PCS bonding
PCS TX channel bonding master Auto, 0 to n-1, n (where n = the number of data channels)
Actual PCS TX channel bonding
master
n-1 (where n = the number of data channels)
TX local clock division factor 1, 2, 4, 8
Number of TX PLL clock inputs per
channel
1, 2, 3, 4
Initial TX PLL clock input selection 0
Enable tx_pma_clkout port On / Off
(41)
Applies when operating in reduced power modes. For mid- and high-power modes, the Enhanced PCS
minimum data rate is 1600 Mbps.
(42)
The Enhanced PCS must be configured in basic low latency mode to support this data rate range.
2-284
Native PHY IP Parameter Settings for Basic (Enhanced PCS) and Basic...
UG-01143
2015.05.11
Altera Corporation
Implementing Protocols in Arria 10 Transceivers
Send Feedback