User guide

Chapter 4: Compiling and Simulating 4–5
Simulating the Design
December 2010 Altera Corporation External Memory Interface Handbook Volume 3
Section II. DDR3 SDRAM Controller with ALTMEMPHY IP User Guide
■ Full calibration—across all pins and chip selects. This option allows for longer
simulation time.
Available for ×4 and ×8 DDR3 SDRAM between 300 MHz and 533 MHz. You
cannot use the wizard-generated memory model, if you select Full Calibration.
You must use a memory-vendor provided memory model that supports write
leveling calibration.
1 If you are simulating your ALTMEMPHY-based design with a Denali model, Altera
recommends that you use full calibration mode.
f For more information about simulation, refer to the Simulation section in volume 4 of
the External Memory Interface Handbook.