User guide

July 2009 Rev 0.06
Page 19 of 31
4.3 Push Button Based SD/HD/3G SDI Evaluation
The EVK can be configured for evaluation by using the push buttons on the Cyclone III main board only. The
push button interface allows the EVK to be configured in the same modes as the terminal interface option.
However, only the Nios II terminal interface allows for device and FPGA register access.
Figure 16 LED and Push Button Locations
4.3.1 Push Button Main Menu
After the FPGA has been programmed, the push buttons default to the main menu options. While in the main
menu, LED 1 will blink. LED 6, 7, or 8 will illuminate to indicate the current configuration of the EVK.
PB 0 PB 1 PB 2 PB 3
System Mode DP Settings Video Format Video Frequency
LED 1 LED 2 LED 3 LED 4 LED 5 LED 6 LED 7 LED 8
Blink Off Off Off Off Genlock Passthroug
h
Standalone
Figure 19) Main Menu Push Button Functions and Board Status LED Indications