Specifications

AlterG M300 Medical Operations Manual Part Number 102508 Rev D
31
CAUTION: At 40% body weight and lower, you can
become unstable if you jump or perform any other
activity besides walking or running. Reduce your body
weight percentage slowly so you can become
accustomed to the new sensation and adjust your gait
mechanics accordingly.
Figure 13. Right side console controls
STEP 4: SELECT TREADMILL DIRECTION
When the treadmill turns on, it is programmed for forward ambulation.
Press the REVERSE button to walk backwards. The green LED next
to the button will light when the treadmill is programmed for reverse.
STEP 5. ADJUST TREADMILL SPEED.
Speed is incremented and decremented by pressing the + or – button
respectively. In the forward direction, speed will increase in .1mph (.16
km/hr) increments for each button push. When the treadmill is
programmed in reverse, speed will increase in .1 mph (.16 km/hr)
increments up to a maximum of 3 mph (4.8 km/hr). Holding either
button down for more than 2 seconds causes the speed to increment
or decrement at a faster rate.
Note: For speeds above a value of 10 (for both mph and kph) the
speed display alternates between the integer and fractional speed
setting.
STEP 6: ADJUST TREADMILL GRADE
Press the + button to increase grade, press the – button to decrease
grade. Holding the button down for more than 2 seconds will cause
grade to change at a more rapid rate.
!
LED indicates current
display
Data display
Select
display
Press for reverse
walking, LED lights
Speed display
Press + to
increase, - to
decrease s
p
eed
Press + to
increase, - to
decrease grade