Specifications

AlterG M300 Medical Operations Manual Part Number 102508 Rev D
32
Note: Treadmill grade cannot be adjusted greater than 5% if
speed is set for less than .5 mph (.8 km/hr).
STEP 7: ENDING THE EXERCISE SESSION
Return the treadmill to 0% incline before stopping your session.
Press the STOP button to end exercise. The treadmill will run through
a shutdown routine and the pressure will be released from the inflated
enclosure. All exercise information will be cleared from the display.
FUNCTION OF THE PAUSE BUTTON
Press the PAUSE button to place the treadmill in the pause mode. The
treadbelt will stop but all statistical information will be preserved. Body
weight support is maintained while in the pause mode. Press the
PAUSE button again to resume exercise.
FUNCTION OF THE DISPLAY BUTTON
Press DISPLAY to choose a different statistic to be displayed. Each
button push causes the display to proceed to the next exercise
variable. The green LED will light next to the variable being displayed.
The following statistics are available for display:
Time
Distance
Incline %
Calories burned (an estimate at 100% BW and 0% grade)
Heart Rate
Pace (minutes/mile)
If the DISPLAY button is held down for more than 2 seconds,
the display will cycle through the data continuously. A second
press will stop the cycling.
STEPPING OUT OF THE TREADMILL
Wait for the treadbelt to stop and the enclosure to fully deflate before
exiting the system. Unzip your shorts and pull the top “skirt” of the
shorts from under the enclosure lip. Open the cockpit lock to
disengage it from its locked position. Lower the cockpit onto the
surface of the treadbelt and exit to the rear of the system.