Specifications

AlterG M300 Medical Operations Manual Part Number 102508 Rev D
40
WEEKLY:
1. Check overall condition of the treadmill.
2. Inspect the fabric enclosure for tears or leaks.
3. Wipe down exterior surfaces with a damp cloth. A mild soap
solution can be used. IMAR™
4
Strataglass Cleaner is
recommended for cleaning the clear windows.
4. Clean the control console with a mild soap solution to remove
grime.
5. Vacuum the interior of the fabric enclosure through the access
hole in the top. You can position the cockpit in the highest
position and crawl inside for better access. Vacuum or wipe
down the deck area between treadbelt and frame.
6. Check shorts for rips or holes.
MONTHLY:
Perform weekly maintenance items and in addition do the following:
1. Unplug the M300. Let sit for 10 minutes.
2. Remove the front third of the base of the bag. Take off the
motor cover and vacuum the inside of the motor area being very
careful to avoid touching sensitive electronics.
3. Clean the rear treadmill mounts
Remove bag from rear third of treadmill
Lift rear of treadmill a few inches so the treadmill rear feet
clear the retaining cups
Reposition treadmill left to expose right load-cell cup
Vacuum debris from inside of cup and the base board
Repeat process moving treadmill to right side exposing the
left cup
Vacuum debris from left cup and base board
4. Feel the surface of the deck under the treadbelt. It should feel
slick and slightly moist with lubricant. If there is debris
accumulation or if it is dry or tacky perform the following:
Wipe the deck and underside of the treadbelt with a clean
towel. Rotate the belt to expose the remaining section and
wipe again.
Apply one 1 ounce packet of SlipCoat
5
under the treadbelt.
Walk for one minute on the treadmill at a low speed to
disperse the lubricant. SlipCoat is very slippery. If you get it
on the top surface of the belt or railings, clean with rubbing
alcohol and a sponge.
SlipCoat may be found online or you can order directly from
AlterG.
5. Check drive belt tension.
6. Check tread belt tension.
4
IMAR is a trademark of IMAR Products, LLC. Manassas, VA.
5
SlipCoat is a product of Landice Inc., Randolph, New Jersey.