Specifications

AlterG M300 Medical Operations Manual Part Number 102508 Rev D

NOTE: It is highly recommended that you employ the

services of a qualified technician to perform the

following maintenance tasks.

ADJUSTING TREADBELT TRACKING

The treadbelt should track in the center of the treadmill deck. If the

tracking needs adjustment, proceed in the following manner.

The treadbelt is tracked by means of two adjustment bolts (9/16"

wrench) located at the rear of treadmill (See Figure 16 on the following

page). By tightening the "close" side and loosing the opposite (same

amount), you can change position of rear roller without changing

overall tension. Adjustments should be made with the treadmill

running, and should be made in 1/4-turn increments. Allow at least 30

seconds for the treadbelt to stabilize between each adjustment.

Turning the treadmill on:

To operate the treadmill independently of the system, the unit must be

in the diagnostic operating mode. To place the system in the

diagnostic mode perform the following:

 Turn the system on with the power switch on the front.

 Wait 30 seconds for the system to go through its startup routine.

 Simultaneously press the %Weight + and – keys.

 Press START. The treadmill display will be activated and the

treadmill can now be operated.

To return to the operational mode after adjustment perform the

following:

 Press STOP. Wait for the treadmill to cycle through its stop

routine.

 Simultaneously press the %Weight + and – keys.

 The system is now in operational mode.

For example, if the treadbelt is tracking to the right:

 Turn treadmill on, and bring speed up to 6.0 mph.

 Using a 9/16" wrench, tighten the right-hand adjustment bolt 1/4

turn.

 Loosen the left-hand adjustment bolt 1/4" turn.

 Let the treadbelt stabilize (rotate for 30 seconds) and readjust if

necessary.

 Return the system to the operational mode.