User's Manual

Index of Tables

This User Manual is applicable to the equipment FiberGateway Altice

GR140DG with the FCC ID: 2ACJF-FGW-GR140DG

FCC NOTICE

This device complies with FCC part 15 rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference and

2. This device must accept any interference, including interference that may cause undesired operation

of the device

Caution:

Changes or modifications not expressly approved by the party responsible for compliance could void

the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates uses and can radiate

radio frequency energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

Consult the dealer or an experienced radio/TV technician for help.

This device meets the FCC requirements for RF exposure in public or uncontrolled environments.

RF Exposure Statement

Note: This transmitter must not be co-located or operated in conjunction with any other antenna or

transmitter.

This equipment should be installed and operated with a minimum distance of 7.9 inches (20 cm)

between the radiator and your body.

This system has been evaluated for RF exposure for humans in reference to ANSI C 95.1 (American

National Standards Institute) limits.

The evaluation was based in accordance with FCC OET Bulletin 65C rev 01.01 in compliance with Part

2.1091 and Part 15.27.

The minimum separation distance from the antenna to general bystander is 7.9 inches (20 cm)

to maintain compliance.