User guide

Chapter 15: Extension Configuration
MAXCS ACC 6.7.1 Administration Manual 185
IP Extension Configuration
See “Setting Up IP Extensions” on page 207 for information on configuring this section
of the Extension Configuration General tab.
Phone Display Options
For analog and IP phones, the administrator can select what information is to be
displayed.
Depending on the number of display lines on the LCD, the phone can be set up to show
two lines of specific caller information on the display.
In the Phone Display field, use the Number Line and Name Line lists to select the
caller information to display:
• Caller Number
Flash Duration
Specifies the Flash Duration time in milliseconds:
• 85-750 (default)
• 50-600
• 100-700
• 150-800
• 200-900
• 300-1000
Ringing Frequency
(Hz)
Select the frequency in Hz that is necessary for the equipment
attached to this line: 28 (default) or 20.
Line Disconnect
Signal
The loop current break desired for answering supervision. Range
600-1000 ms (1000 ms is default).
Caller ID
Transmission
Methods
Specifies how Caller ID will be detected:
• CID between 1st and 2nd ring - Caller ID is received between
first and second ring. (Most common in US/Canada)
• DT-AS+CID prior to ringing - Dual Tone Alerting Signal Caller
ID is received prior to ringing.
• RP-AS+CID prior to ringing - Ring Pulse Alerting Signal Caller
ID is received prior to ringing.
Receive from phone
(dB Gain)
Range -3 ~ +3 db
You can decrease or increase the extension phone's talk volume
with this setting. Default is 0 dB.
Transmit to phone
(dB Gain)
Range -3 ~ +3db
You can decrease or increase the extension phone's receiving
volume with this setting. The volume will be lower or higher for
the extension user. Default is 0 dB.
Parameter Description