Configuration with AudioCodes Instruction Manual

Configuring Analog Extensions with AudioCodes Gateways Page 12 of 25
9. Select VoIP > Coders and profiles > Coders. Make sure that both G.711U-law and G.729 are in the list.
Figure 15: Confirm that G.711U-law and G.729 are listed in Coders and Profiles
10. Select VoIP > GW and IP to IP > Hunt Group > Endpoint Phone Number. Configure Entry 1 as follows.
Figure 16: Configure the endpoint phone extension
• Set Channel(s) to 1. (This means the first FXS port.)
• Set Phone Number to 167 (refer to the extension in
Figure 1).
• Set Hunt Group ID to 1.
• Set Tel Profile ID to 0.