User`s guide

MT104
MT104MT104
MT104-
--
-102
102102
102 User’s Guide
400-0092-006
8
9. [?]
This command displays general information about a MultiTasker and
its installed cards.
Command Format: [?Ui]
Ui = Unit ID (i = from 0 to 20)
Example:
A MultiTasker with unit ID 0 has a front panel with model number
MT101-110, and contains an MT104-102 in slot 4. Send the command
[?] and receive feedback similar to the following:
[(MT101-110U0)(MT104-102C04)(MT105-108C06)(MT106-103C08)]
MT101-111U0 = Panel model number/unit ID
MT104-102C04 = MT104-102 is in slot 4
MT105-108C06 = MT105-108 is in slot 6
MT106-103C08 = MT106-103 is in slot 8
10. [?C]
This command displays general information about a card and its status.
Command Format: [?Cn]
Cn = Card ID (n = # from 1 to max slots)
Example:
The MT104-102 in slot 4 has Input 1 ON. Send [?C4] to display the
feedback status.
[(MT104-102C04)(VR690-0158-007C04)(IN2C04)]
All status feedback is enclosed in brackets, "[ ]". Each data field within
the status is enclosed in parentheses. The first two characters identify
the status type. The last three characters are the card’s ID.
11. [STA1]
This command enables automatic feedback from the front panel. The
command affects any card with auto feedback capability, not just the
MT104-102. The default at power on or reset is STA0, off. For more
details, see the [?Cn] command definition.
Command Format: [STA1]
Feedback Prefix Definitions:
MT = Model Number
VR = Firmware Version
IN = Input Selected
Example:
Command = [ON2C4]
Feedback = [ ] (IN2C04)
IN = Input
2 = Input Number
12. [STA0]
This command disables automatic feedback from the card and front
panel. The command affects any card with auto feedback capability,
not just the MT104-102. The default at power-on or reset is STA0,
OFF.
Command Format: [STA0]
13. [...F]
After processing a command, an OK or [ERR001] will be returned as
feedback if "F" is included at the end of a command string.
Command = [ON2C2F]
Feedback = OK
Card Control
Card control commands allow the main card functions to be executed over
the RS-232 bus, or from the MultiTasker front panel.
14. [ON]
This command selects an input and enables the output.
Command Format: [ONmCn]
m = Input number (m = # from 1 to 6 slots)
Cn = Card ID (n = # from 1 to max slots)
Example:
The command [ON2C4] connects the signal on Input 2 of C4 to the
output and enables the output.
15. [OFF]
This command disables the output without changing the selected
input.
Command Format: [OFFCn]
Cn = Card ID (n = # from 1 to max slots)
Example:
Send the command [OFFC4] to disable the output of C4.