User`s guide

MULTITASKER
400-0226-004
13
CARD CONTROL COMMANDS
11. [ImOx]
This command connects a single input to a
single output.
Command Format: [ImOxCn]
m = Input no. (m= # from 1 to max inputs)
x = Output no. (x = # from 1 to 8)
Cn = Card ID (n = slot # from 1 to max slots)
Example:
Connect Input 1 to Output 1 of the MT105-110 in
slot 4. Send the command [I1O1C4] and Input 1
will be connected to Output 1.
12. [ImO*]
This command connects a single input to all the
outputs.
Command Format: [ImO*Cn]
m = Input no. (m = # from 1 to max inputs)
Cn = Card ID (n = slot # from 1 to max slots)
Example:
Connect Input 1 to all outputs of the MT105-110
in slot 4. Send the command [I1O*C4] and
Input 1 will be connected to all outputs.
13. [CLR]
This command clears the input-to-output
connects and restores the card to its default
settings. After sending the [CLR] command,
Input 1 will be connected to all outputs and all
outputs will be enabled.
Command Format: [CLRCn]
Cn = Card ID (n = slot # from 1 to max slots)
Example:
Clear the MT105-110 in slot 4 by sending
[CLRC4].
14. [ON]
This command will enable an output of a single
card, or a group of cards.
SINGLE CARD OPERATION
Command Format: [ONmCn]
m = Output no. (m = # from 1-8)
Cn = Card ID (n = # from 1 to max slots)
Example:
There is an MT105-110 card in slot 4. All of the
outputs on the card are off.
1) [ON1C4]: Turns on only Output 1.
2) [ONC4]: Turns on all outputs.
GROUP OPERATION
This command enables output "m" for each card
in group "k".
Command Format: [ONmGk]
m = Output no. (m = # from 1-8)
Gk = Group no. (k = # from 1-8)
Example:
[ON1G1]: Turns on Output 1 for each card in
G1. See the GROUP commands for a detailed
explanation.
PATH OPERATION
This command will set the path for the output,
but it is not active until the switch command,
[SW], is executed. Commands ending in "P" are
not executed immediately. The path for outputs
on multiple cards or the same card may be
preloaded.
Command Format: [ONmCnP]
m = Output no. (m = # from 1 to 8)
Cn = Card ID (n = slot # from 1 to max slots)
P = Path