User`s guide

MULTITASKER
400-0226-004
14
Example:
There are two MT105-110 cards, C6 and C7.
Enable Output 1 of C6 and Output 3 of C7
simultaneously. To do this, send the following
commands:
[ON1C6P]
[ON3C7P]
[SW]
15. [OFF]
This command disables one or all outputs of a
single card or a group of cards.
SINGLE CARD OPERATION
Command Format: [OFFmCn]
m = Output no. (m = # from 1 to 8)
Cn = Card ID (n = # from 1 to max slots)
Example:
C5 has Output 1 on. The following commands
may be used to turn off the output.
1) [OFF1C5]: Turns off only Output 1.
2) [OFFC5]: Turns off all outputs.
GROUP OPERATION
This command disables output "m" for each card
in group "k".
Command Format: [OFFmGk]
m = Output no. (m = # from 1-8)
Gk = Group ID (k = # from 1-8)
Example:
1. [OFF1G1]: Turns off Output 1 for each card
in G1.
2. [OFFG1]: Turns off all outputs for each
card in G1.
PATH OPERATION
This command will set the path for the output,
but it is not active until the switch command,
[SW], is executed. Commands ending in "P" are
not executed immediately. The path for outputs
on multiple cards or the same card may be
preloaded.
Command Format: [OFFmCnP]
m = Output no. (m = # from 1 to 8)
Cn = Card ID (n = # from 1 to max slots)
P = Path
Example:
There are two MT105-110 cards, C6 and C7.
Disable Output 1 of C6 and Output 3 of C7
simultaneously using the following commands:
[OFF1C6P]
[OFF3C7P]
[SW]
16. […S] – SAVE
This command will save the configuration
command being sent in memory. When sending
the command [I1O1C4S], after reset or power
up, Input 1 will be connected to Output 1 on C4.
This command only saves the Input 1 to
Output 1 connection above. In order to save all
the current settings, use the [CnS] command.
17. […F] – FEEDBACK
After processing a command, an “OK” or error
message in the form of “[ERR001]” will be
returned as feedback if “F” is included at the end
of a command string.
18. […P] – PATH
This command will set the path for the output,
but it is not active until the switch command,
[SW], is executed. Commands ending in "P" are
not executed immediately. The path for outputs
on multiple cards or the same card can be
preloaded. See the examples in the [ON] and
[OFF] commands.