User`s guide

MULTITASKER
400-0226-004
18
28. [RMG]
This command deletes one or all groups.
Command Format: [RMGk]
Gk = Group ID (k = # from 1-8, * for all)
Example:
Remove all cards from G52 by sending [RMG5].
The system will return the following feedback:
[G5=0]
Example 2:
Remove all cards from all groups, effectively
deleting all groups, by sending [RMG*]. The
system will return the following feedback:
G1-G8: EMPTY
29. [RD]
This command reads and then displays the
members in a group.
Command Format: [RDGk]
Gk = Group ID (k = # from 1-8)
Example:
C2, C4, and C6 make up G5. Read the member
data for G5 by sending the command [RDG5].
The system will return feedback as follows:
[G5=C2C4C6]
The feedback shows G5 and then the cards that
make up G5. In this case, G5 includes C2, C4,
and C6.
7.3. SUMMARY OF COMMANDS
Basic Commands
1) [VER] Display firmware version
2) [C] Display card status
3) [CnS] Save card settings
4) [TEST] Test internal memory ICs
5) [HELP] Display available commands
Feedback Commands
6) [FBD] Feedback delay on/off
7) [?] Display system cards
8) [?C] Display card information
9) [STA1] Auto-feedback on
10) [STA0] Auto-feedback off
Card Control Commands
11) [IO] Connect input to output
12) [IO*] Connect input to all outputs
13) [CLR] Reset card to defaults
14) [ON] Enable one or more outputs
15) [OFF] Disable one or more outputs
16) […S] Save command being sent
17) […F] Display “OK” feedback
18) […P] Set the path, [SW] preload
19) [SW] Switch preloaded output
20) [MAT] Set matrix configuration
ID Commands
21) [RSI] Reset Card IDs to defaults
22) [SIDn] Set all Card IDs
23) [SIDnCi] Set one Card ID
24) [SID+] Set all Card IDs to an offset
25) [RSN] Display card slot number
Group Commands
26) [WR] Add card(s) to a group
27) [RMC] Remove card(s) from group
28) [RMG] Delete group
29) [RD] Display group members