User`s guide

MULTI-TASKER™
10
10
7.2 DESCRIPTION OF COMMANDS
Each command consists of three parts:
Function, Card ID, and Unit ID.
[ Function , Card ID , Unit ID ]
Example: [VERC3U2]
VER = Function
C3 = Card ID
U2 = Unit ID
For Function, see a detailed explanation under
each command description.
The Card ID is an assigned value. It is equal to
the enclosure slot number in which the card is
installed. The value can range from 1 to 4,
1 to 8, or 1 to 19 depending on the enclosure.
Card ID 0 (C0) is used for the controller. See
the MT100-100 User’s Guide for details.
Changing the position of a card will significantly
affect the commands recorded on software
definitions or third party control systems.
The Unit ID has a value from 0 to 9. Unit ID 0
should be used for single unit operation. If the
Unit ID is set to zero, each command may be
used without Ui. Use the command [SETU0],
as explained in the MT100-100 User’s Guide.
Example:
[VERC3]: For Unit ID Zero
[VERC3Ui]: For Unit ID other than Zero
[VERC3]: Equivalent to [VERC3U0]
1. [VER]
This command displays the software version
and card type for the card.
Command Format: [VERCnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
Send the command [VERC2] to check the
version of the MT109-100 in slot 2. The system
will return the following feedback:
MT109-100 690-0179-003
MT109-100 = card type
690-0179-003 = software version
2. [C]
This command receives the status of the card.
Command Format: [CnUi]
Cn = card ID (n = # from 1 to max slots)
Ui = unit id (i = 0 to 9)
Example:
An MT109-100 card is in slot #4. Sending the
command [C4] to the Multi-Tasker™ will yield
feedback similar to the following:
ON 1 C04
OUTVOL=32/32
INVOL1=32/32
INVOL2=32/32
INVOL3=32/32
INVOL4=32/32
INVOL5=32/32
INVOL6=32/32
INVOL7=32/32
INVOL8=32/32
If there is no card in slot #4, sending the [C4]
command will not return any feedback.
3. [CnS]
This command saves the status of the card's
current settings. This configuration will be
restored after system is reset or powered off
then on.
Cn = card number
S = save configuration