User`s guide

MULTI-TASKER™
11
11
Example:
Save the card's current settings by sending the
command [C4S]. The feedback will indicate the
card settings were saved and display the saved
settings. In the example below, the output
volume is set to 20, the active input is 5 and all
the input volumes are set to 16.
ON 5 C04 Saved
OUTVOL=20/32
INVOL1=16/32
INVOL2=16/32
INVOL3=16/32
INVOL4=16/32
INVOL5=16/32
INVOL6=16/32
INVOL7=16/32
INVOL8=16/32
4. [?]
This command will return general information
about the card and the status.
Command Format: [?CnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = from 0 to 9)
Example:
Send the command [?C5] to receive the
feedback for the MT109-100 in slot #5. Each
status field begins with a '+' and ends with the
card slot number (ex: C05). The feedback will
be similar to the following:
[+MT109-100C05+VR690-0179-003C05
+IN1C05+VO32C05+VI3232323232323232C05
+VM0C05]
MT109-100 = Card Type
VR690-0179-003 = Firmware version
IN1 = Input 1 is the selected input
VO32 = Output volume is at 32
VI3232323232323232 = Input 1-8 volume levels
in two digit format
5. [CLR]
This command clears the card's settings and
returns them to the factory defaults.
Command Format: [CLRCnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = from 0 to 9)
Example:
Send the command [CLRC5] to reset the
MT109-100 in slot #5 to its factory defaults.
6. [STA]
This command enables/disables automatic
feedback from the front panel. The command
affects any card with auto -feedback capability,
not just the MT109-100.
Command Format [STA1] = ON
Command Format [STA0] = OFF
Feedback Prefix Definitions:
+VR = Firmware Version
+IN = Input Selected
+VO = Output Volume
+VI = Input Volume
+VM = Mute Control
Example 1:
Command = [ON1C5]
Feedback = [+IN1C05]
+IN = Input Select
1 = Selected Input
C05 = Card slot number
Example 2:
Command = [VOL1A22C5]
Feedback = [+VO16C05]
+VO = Output Volume
16 = Volume Level
C05 = Card slot number