User`s guide

MULTI-TASKER™
13
13
11. [RDN]
This command ramps the output volume down
to a level of 1 at a rate defined using the
[RAMP] command.
Command Format: [RDNCnUi]
Cn = Card Slot Number
Ui = Unit ID (i = # from 0 to 9)
Example:
Ramp the output volume from a starting level of
32 down to 1 for the card in slot #8. Send the
command [RDNC8] and the system will respond
with the following feedback:
[31][30][29]…[01]
12. [RDN=xx]
This command ramps the output volume down
to a user defined level at a rate defined using
the [RAMP] command.
Command Format: [RDN=xxCnUi]
xx = Stop Level (xx = # from 01-32)
Cn = Card Slot Number
Ui = Unit ID (i = # from 0 to 9)
Example:
Ramp the output volume from a starting level of
32 down to 16 for the card in slot #8. Send the
command [RDN=16C8] and the system will
respond with the following feedback:
[31][30][29]…[16]
13. [RAMP]
This command displays the ramping time for 32
steps. The time between each step is equal to
the time in seconds divided by 32.
Command Format: [RAMPCnUi]
Cn = Card Slot Number
Ui = Unit ID (i = # from 0 to 9)
Example:
Display the ramp rate setting for the card in slot
#8 by sending the command [RAMPC8]. The
system will respond with feedback similar to the
following:
RAMPTIME = 6 SECONDS
14. [RAMP=x]
This command sets the ramp rate for 32 steps.
The settings range from 4 to 18 seconds, in
two-second intervals.
Command Format: [RAMP=xCnUi]
x = Rate in Seconds
4 = 0.13 seconds/step
6 = 0.19 seconds/step
8 = 0.25 seconds/step
10 = 0.31 seconds/step
12 = 0.38 seconds/step
14 = 0.44 seconds/step
16 = 0.50 seconds/step
18 = 0.56 seconds/step
Cn = Card Slot Number
Ui = Unit ID (i = # from 0 to 9)
Example:
There is an MT109-100 in slot #5. Send the
command [RAMP=16C5] to set the ramp rate to
16 seconds. After this is set, any ramping will
occur at a rate of 32 steps in 10 seconds, or
0.50 seconds per step. Confirm the setting by
sending the command [RAMPC5] and receiving
the feedback:
RAMPTIME = 10 SECONDS
15. [RST]
This command stops ramping and maintains the
last volume setting.
Command Format: [RSTCnUi]
Cn = Card Slot Number
Ui = Unit ID (i = # from 0 to 9)