User`s guide

MULTI-TASKER™
15
15
19. [OFF]
This command turns off the output volume
without changing the input selection or any
volume settings, and is equivalent to the
[MUT1] command.
Command Format: [OFFmCnUi]
m = Input number (m = # from 1 to 8)
n = Card ID (n = # from 1 to max slots)
i = Unit ID (i = # from 0 to 9)
Example:
Card 5 has Input 1 ON and a volume level of
16. Sending the command [OFFC5], turns OFF
the output volume, but leaves the volume
settings unchanged. When the output volume is
turned back on, the original volume level of 16
will be retained.
PATH OPERATION
Command Format: [OFFmCnUiP]
This command will set the path for the output,
but it is not active until the switch command,
[SW], is executed. Commands ending in "P" are
not executed immediately. The path for outputs
on multiple cards or the same card may be
preloaded.
m = Input number (m = 1 to 8)
n = Card ID (n = # from 1 to max slots)
i = Unit ID (i = # from 0 to 9)
P = Path
Example:
There are two MT109-100 cards in slots 6 and
7. Turn OFF the output volume on both cards
simultaneously using the commands:
[OFFC6P]
[OFFC7P]
[SW]
If "F" is included, use the [OFFmCnUiPF]
command or the [OFFmCnUiFP] command.
FEEDBACK OPERATION
Command Format: [OFF…..F]
After processing a command, an OK or ER will
be returned as feedback if "F" is included at the
end of a command string.
Example:
[OFFC2F]: if path is not set
[OFFC2PF]: if path is set
20. […S] – Save
This command will save the configuration
command being sent in memory. When
sending the command [VOL1A16C5S], after
reset or power up, Input 1 on C5 will be
restored with an input volume level of 16.
21. […F] – Feedback
After processing a command, an OK or ER will
be returned as feedback if "F" is included at the
end of a command string.
22. […P] – Path
This command will set the path for the output,
but it is not active until the switch command,
[SW], is executed. Commands ending in "P" are
not executed immediately. The path for outputs
on multiple cards or the same card can be
preloaded. See examples in ON and OFF
commands.
23. [SW] – Switch
The switch command immediately connects
inputs and outputs, which were previously set
with the path command on this card and all
other cards in the MT100-100.
Example:
[ON1C6P]
[ON3C7P]
[SW]
The system will return feedback as OK if the
unit ID is zero.