User`s guide

MULTI-TASKER™
17
17
29. [CLM]
This command removes the members in a
group and leaves the group empty.
Command Format: [CLMGkUi]
Gk = Group number (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
Group 5 of Unit ID 1 contains the cards in slots
1, 2 and 19. Read the member data for group 5
of Unit ID 1. Send the command [RDG5U1]
and receive the following feedback:
C1C2C19 G5U1
Now, clear group 5 by sending the command
[CLMG5U1]. Reread the member data as above
and note the following feedback:
NONE G5U1
7.3. SUMMARY OF COMMANDS
Card Commands
1) [VER] Receives software version
2) [C] Receives status of the card
3) [CnS] Save card settings
4) [?] Show status/ general information
5) [CLR] Reset card to default values
6) [STA] Enable/disable auto feedback
7) [SEL] Select input volume to adjust
[ + ][ - ] Adjust volume levels
8) [VOL] Set an absolute volume level
9) [RUP] Ramp volume UP to 32
10) [RUP=] Ramp volume UP to a value
11) [RDN] Ramp volume DOWN to 1
12) [RDN=] Ramp volume DOWN to a value
13) [RAMP] Return ramp rate
14) [RAMP=] Set ramp rate
15) [RST] Stop ramping
16) [MUT0] Mute OFF
17) [MUT1] Mute ON
18) [ON] Output volume ON or select input
19) [OFF] Turn output volume ON/FF
20) […S] Save the command configuration
21) […F] Provides feedback upon sending
22) […P] Sets the path, preload for [SW]
23) [SW] Switch preloaded output buffer
24) [TEST] Perform board memory test
25) [HELP] Display available commands
Group Commands
26) [WR] Groups multiple cards
27) [CLRG] Clears group members
28) [RD] Displays group members
29) [CLM] Removes members from group.
7.4 MENU MODE
MENU MODE commands are RS-232 commands
that allow the same functionality as programming
commands. Unlike the programming commands in
the previous sections, 7.2 and 7.3, MENU
commands prompt the user to select from a list of
available commands. The system then responds
based upon selections made by the user.
MENU commands may be issued in response to
prompts from within MTSetup™ or other RS-232
communication software.
The MENU driven commands are only available
with Multi-Tasker™ Front Panel systems that have
the following firmware:
690-0122-015 = Version 015 or later.
690-0123-004 = Version 004 or later.
690-0124-015 = Version 018 or later.
NOTE: In MTSetup™, send the command [VER]
from the Terminal Window. The system will
respond with feedback similar to the following:
[690-0122-015 690-0123-004 690-0124-018]