User`s guide

MULTI-TASKER™
400-0356-002
9
9
The Unit ID has a value from 0 to 9. Unit ID 0
should be used for single unit operation. If the
Unit ID is set to 0, then each command can be
used without Ui. Use command [SETU0] to set
Unit ID 0. See the MT100-100 User’s Guide for
more information.
Example:
[VERC3]: for unit ID zero
[VERC3Ui]: for unit ID other than zero
[VERC3]: equivalent to [VERC3U0]
1. [C]
This command displays the status of the card.
Command Format: [CnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = from 0 to 9)
Example:
There is an MT112-100 card is in slot #4. All I/O
ports are ON. Send the command [C4], and the
system will return the following feedback:
01-08: 11111111
09-16: 11111111
17-24: 11111111
The feedback provides the current state of the
MT112-100. The IO Status shows all 1's, or ON.
2. [CLR]
This command performs a reset of the card and
restores settings to the factory defaults. The
subroutines stored in memory are not affected
by this command. In order to clear the
subroutine memory, see the [CLRS] command.
Command Format: [CLRCnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = from 0 to 9)
Example:
Send the command [CLRC4] to reset the card in
slot #4 to factory defaults. After sending the
command the feedback will be as follows:
[PLEASE WAIT]
Upon completion, the card will return the
following feedback:
[FACTORY RESET COMPLETED]
After the reset, the status [C4] will be as follows:
01-08: 11111111
09-16: 11111111
17-24: 11111111
3. [TEST]
This command performs a test of the memory
IC's on the MT112-100.
Command Format: [TESTCnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = from 0 to 9)
Example:
Perform a test of the memory on the
MT112-100 in slot #2. Send the command
[TESTC2] and observe the following feedback:
MEMORY IC TEST RESULTS
U14 OK
U19 OK
U20 OK
U21 OK
U31 OK
U32 OK
4. [?]
This command will return general information
about the Multi-Tasker™ and cards installed in
the unit.
Command Format: [?Ui]
Ui = Unit ID (i = from 0 to 9)
Example:
A Multi-Tasker™ with Unit ID #1 has a front
panel with part number MT101-101 and
contains an MT103-122, MT103-123 and
MT112-100. Send the command [?U1] and
receive the following feedback: