User`s guide

MULTI-TASKER™
400-0356-002
10
10
[(MT101-101U1)(MT103-122C01)
(MT103-123C02)(MT112-100C03)]
MT101-101U1 = Panel Number and Unit ID
MT103-122C01 = An MT103-122 is in slot 1
MT103-123C02 = An MT103-123 is in slot 2
MT112-100C03 = An MT112-100 is in slot 3
5. [?Cn]
This command will return general information
about the card and its status. It is a function of
both the card and the front panel and is only
available with Multi-Tasker™ Front Panel
systems that have the following firmware:
690-0122-015 = Version 015 or later.
690-0123-004 = Version 004 or later.
690-0124-018 = Version 018 or later.
NOTE: In MTSetup™, send the command
[VER] from the Terminal Window. The system
will respond with feedback that includes the
following:
690-0122-015 690-0123-004 690-0124-018
Check the last three digits against the numbers
above to determine if the option is available.
Command Format: [?CnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = from 0 to 9)
Example:
Send the command [?C4] to receive the
feedback for the MT112-100 in slot #4:
All status feedback is enclosed in brackets, “[ ]“.
Each data field within the status is enclosed in
parentheses. The first two characters identify
the status type. The last three characters are
the card’s ID. The feedback will be similar to the
following:
[(MT112-100C04)(VR690-0185-003C04)
(ON111111111111111111111111C04)]
MT112-100 = model number
VR690-0185-001 = firmware version
ON1111… = IO Port Status (1-24)
The I/O port settings are read left to right
representing ports one through 24. A “0”
indicates the port is low and a “1” indicates the
port is high.
6. [STA1]
This command enables automatic feedback
from the front panel. The command affects any
card with auto-feedback capability, not just the
MT112-100. The default at power on or reset is
STA0, OFF. For more details, see the [?Cn]
command definition.
Command Format [STA1]
MT Model Number
VR Firmware Revision
IO IO Port Status
Example:
Command = [WRIO1=0C4]
Feedback = (IO0111…1111C02)
IO = IO Status
011… = Port 1=Low
Port 2=High
Port 3=High etc…
C04 = Card/Slot number
7. [STA0]
This command disables automatic feedback
from the card and front panel. The command
affects any card with auto-feedback capability,
not just the MT112-100. The default at power on
or reset is STA0, OFF.
Command Format [STA0]
8. [VER]
This command receives the software version
and card type for the MT112-100 card.
Command Format: [VERCnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
There is an MT112-100 in slot #4. Send the
command [VERC4] and receive the following
feedback: