User`s guide

MULTI-TASKER™
400-0356-002
17
17
Command Format: [RMGkUi]
Gk = Group number (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
Group 5 consists of the cards located in slots
number 2, 4 and 6. Remove all cards from the
group by sending the command [RMG5]. The
system will return the following feedback:
[G5=0]
REMOVE ALL GROUPS
Remove all the members from every group,
effectively deleting all groups.
Command Format: [RMG*Ui]
Ui = Unit ID (i = # from 0-9)
Example:
Group 5 consists of cards 2, 4 and 6. Group 2
consists of cards 1, 2, 3, 4 and 5. Delete all the
groups by sending the command [RMG*]. The
system will return the following feedback:
G1-G8:EMPTY
32. [RD]
This command reads and then displays the
members in each group.
Command Format: [RDGkUi]
Gk = Group number (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
The cards in slots 2, 4 and 6 are part of
group 5. Read the member data for group 5, by
sending the command [RDG5]. The system will
return feedback as follows:
[G5=C2C4C6]
The feedback shows G5 (Group 5) and then the
cards that make up Group 5. In this case,
Group 1 includes C2, C4 and C6.
33. [CLRG]
This command clears the members for a single
group or for all groups. The clear command
restores the cards to default settings and is the
equivalent to sending the [CLR] command to
each individual card.
NOTE: Since this command is sending the
[CLR] command to its group members,
each card will display its own reset
message, if any.
Command Format: [CLRGkUi]
Gk = Group ID (k = # from 1-8, or * for all)
Ui = Unit ID (i = # from 0-9)
Example:
1) To clear group 1 of Unit ID 0, send the
[CLRG1] command. This command clears
the members for the specified group only.
2) To clear all groups of Unit ID 1, send the
[CLRG*U1] command.
34. [CLM]
This command removes the members in a
group and leaves the group empty.
Command Format: [CLMGkUi]
Gk = Group number (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
Group 5 of Unit ID 1 contains the cards in slots
2, 4 and 6. Read the member data for group 5
of Unit ID 1. Send the command [RDG5U1] and
receive the following feedback:
[G5=C2C4C6]
Now, clear group 5 by sending the command
[CLMG5U1]. Reread the member data as above
and note the following feedback:
[G5=0]