DESIGNER SOLUTIONS MANUAL PART NUMBER: 400-0208-001 TNP100-HB Tilt ‘N Plug™ Interconnect Box USER'S GUIDE
DESIGNER SOLUTIONS TABLE OF CONTENTS Page PRECAUTIONS / SAFETY WARNINGS............. GENERAL ................................ ....................... INSTALLATION ................................ ............... CLEANING ................................ ...................... FCC / CE NOTICE................................ ........... 2 2 2 2 2 ABOUT YOUR TNP100-HB................................ 3 TECHNICAL SPECIFICATIONS ......................... 3 TNP100-HB DIMENSIONS ................................ .
DESIGNER SOLUTIONS PRECAUTIONS / SAFETY WARNINGS cause serious injury because of the sharp edges inside of the TNP100-HB. 1 Please read this manual carefully before using your TNP100-HB Interconnect Box. Keep this manual handy for future reference. These safety instructions are to ensure the long life of your TNP100-HB and to prevent fire and shock hazard. Please read them carefully and heed all warnings. • Do not place heavy objects on top of the TNP100-HB.
DESIGNER SOLUTIONS Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. • TECHNICAL SPECIFICATIONS FEATURES/ DESCRIPTION GENERAL Front Panel Standard Configuration Connectors Any changes or modifications to the unit not expressly approved by ALTINEX, Inc. could void the user’s authority to operate the equipment.
DESIGNER SOLUTIONS TNP100-HB DIMENSIONS 4 Diagrams: 1A, 1B, 1C, & 1D 4
DESIGNER SOLUTIONS DESCRIPTION DIAGRAM 5 Diagram 2: TNP100-HB Faceplate APPLICATION DIAGRAM 6 Diagram 3: Application 5
DESIGNER SOLUTIONS Diagram 4: Final Installation 6
DESIGNER SOLUTIONS Diagram 5: Table Cutout Requirements 7
DESIGNER SOLUTIONS INSTALLATION Step 5. 7 Step 1. Cut an opening into the table’s surface. Refer to diagram 5 on page 7 of the manual for table cutout requirements. Note: The table can be 3 inches or thinner in thickness. Always confirm dimensions before cutting to insure that specifications have not changed. Connect the appropriate cables with the correct input connectors.
DESIGNER SOLUTIONS OPERATION FREQUENTLY ASKED QUESTIONS (FAQ) 8 No: 1. The TNP100-HB unit will operate successfully as long as all cables are attached properly and other technical specifications are maintained. 2. 3. 9 Question What happens if the spring breaks? What do I do if the TNP100-HB won’t stay open? How much room is taken up on the underside of the table? 4. What if my table is thicker than 3 inches? 5.
DESIGNER SOLUTIONS ACCESSORIES 10 TROUBLESHOOTING GUIDE 11 The supplied TNP100-HB unit was carefully tested and no problems were detected; however, we would like to offer the following suggestions: Model No.
DESIGNER SOLUTIONS ALTINEX POLICY returned without an RMA experience a delay in service. 12 12.1 LIMITED WARRANTY number may If your product is out of warranty and needs service, contact the ALTINEX Sales Department for an RMA (Return Material Authorization). Products returned without an RMA number may experience a delay in service. The service charges will be quoted to you before the actual repairs are done.
