Owner's Manual

Caring for Your Radio
Note : DO NOT operate the radio without a proper 50 Ohm antenna
attached, as this may damage the radio
Connecting the antenna
Align the base of the antenna onto the SMA connector
and turn clockwise until snug. Do not over tighten.
Disconnecting the antenna
Turn the base of the antenna counter-clockwise to
disconnect it from the radio.
Standby Mode
When Battery low
When you press and
hold Talk button and
the Radio is
transmitting
During VOX feature
enabled
During Emergency
Alert Mode
Power Off the Radio during charging
Under Charging
Fully Charge
Operation
Using Your Radio
LED indicators
2 3
Maximum range may vary and is based on
unobstructed line-of-sight communication
under ideal conditions.
Features
• 5 Channels with
Preset privacy
codes
• User Adjustable
Privacy Codes
(39 CTCSS codes
168 DTS codes)
• Hands-Free
Operation (VOX)
• Button Lock
• Speaker/
Microphone/
Charge Jack
• Roger Beep
Selectable On/Off
• Battery/Power
Saver
• Low Battery
Audible Alert
• Auto Squelch
• Maximum Range
Extender
• Emergency Call
Connecting Antenna
Disconnecting
Antenna
Green LED ashes every
5 seconds
Red LED ashes every 1
second
Green LED on
After Green LED ashes
every 5 seconds
Red LED ashes 6 times
Solid Green (No ash)
Solid Red (No ash)
Solid Green (No ash)
Caring for Your microTALK
®
Radio
Your microTALK
®
radio will give you years of trouble-free service if cared for
properly. Handle the radio gently. Keep the radio away from dust. Never put the
radio in water or in a damp place. Avoid exposure to extreme temperatures.
Only use the supplied rechargeable batteries and desktop charger for
recharging your Cobra microTALK
®
radio.
Please charge new batteries for 8 hours for rst time of use.
Cobra recommends your radio is turned off while being charged.