Owner's Manual

Memory Scan
•
Your microTALK
®
radio can automatically scan the stored memory
locations.(See page 10 for setting memory locations)
To scan memory locations:
1. Make sure 2 or more memory locations
programmed already.
2. Press and release the MEM/ESC button to enter
Memory mode from Standby mode.
Memory icon and the Memory Location show
on the display.
3. Press and release the Scan button, Scan
icon and Memory icon will be displayed
simultaneously and then begin scanning stored
channel locations.
The Scan icon will continue to be displayed when
Memory Scan is On.
Your radio will continue to scan memory locations
and stop as an incoming transmission is detected.
Your radio will remain on that stored channel/
privacy code for 6 seconds.
M
E
M
E
S
C
M
a
x
R
a
n
g
e
H
I
/
L
O
W
S
MEM/ESC Button
a
x
R
a
n
g
e
I
/
L
O
W
S
c
a
n
Scan Button
M
E
M
E
S
C
H
I
/
L
O
W
S
c
a
n
Channel Button
Hazards Radio Icon
W
S
c
a
n
Channel Button
Weather Button
NOAA* All Hazards Radio Channels
•
You can use your microTALK
®
radio to listen to NOAA All Hazards
Radio channels transmitting in your area.
To listen to All Hazards Radio channels:
1. Press the Weather button until the All Hazards
Radio icon and the currently selected All Hazards
Radio channel are displayed.
2. Use the Channel Up or Channel Down
button to change All Hazards Radio channels.
3. The All Hazards Radio icon will continue to
be displayed when All Hazards Radio is on.
4. To exit All Hazards Radio, press and hold the
Weather button until “All Hazards Radio” icon
is off.
*National Oceanographic and Atmospheric Administration
18