User Guide English ( 3 – 8 ) Guía del usuario Español ( 9 – 14 ) Guide d’utilisation Français ( 15 – 20 ) Guida per l’uso Italiano ( 21 – 26 ) Benutzerhandbuch Deutsch ( 27 – 32 ) Gebruikershandleiding Nederlands ( 33 – 38 ) Appendix English ( 39 – 42 )
User Guide (English) Introduction Thank you for purchasing the TS3 Series loudspeaker. At Alto Professional, performance and reliability mean as much to us as they do to you. That’s why we design our equipment with only one thing in mind—to make your performance the best it can be. Box Contents TS3 Series Loudspeaker Power Cable User Guide Safety & Warranty Manual Support For the latest information about this product (system requirements, compatibility information, etc.
Important Safety Precautions Please note: Alto Professional and inMusic are not responsible for the use of its products or the misuse of this information for any purpose. Alto Professional and inMusic are not responsible for the misuse of its products caused by avoiding compliance with inspection and maintenance procedures. Please also refer to the included safety and warranty manual for more information.
Setup Volume Control The TS3 Series loudspeaker accepts both line-level and mic-level audio sources. Before connecting your audio source, turn the Volume knob to the minimum position (fully counter-clockwise). Line-Level Audio Source When using an audio source such as a mixer, CD/MP3 player or audio preamp, follow the outer/Line level band indicator. If the Signal Limit LED is on, do not advance the Volume knob any further. Doing so may damage your TS3 loudspeaker.
Examples Items not listed under Introduction > Box Contents are sold separately. Note: These examples show the rear panel used by the TS310, TS312, and TS315 models, though all four models in the TS3 Series have the same input and output. Example A: One Loudspeaker Microphone Guitar Connect a dynamic microphone to the Input 1 using an XLR or 1/4” (6.35 mm) TRS cable. Connect a guitar with an active pickup to the Input 2 using a 1/4” (6.
Example C: Two Loudspeakers + Two Extensions Connect each of your mixer’s main outputs to Input 1 on each TS3 loudspeaker. Connect the Mix Out of each TS3 loudspeaker to an input of each extension loudspeaker. Do not turn any of the Volume knobs past the 0 dB position.
Features Rear Panel 1. AC Input: Use the included power cable to connect this input to a power outlet. Make sure the Power Switch is set to off when connecting or disconnecting the cable. 2. Fuse: If the unit’s fuse is broken, lift this tab to replace the fuse. Replace it with a fuse with an appropriate rating (printed under the unit’s power cable input). Using a fuse with an incorrect rating can damage the unit and/or fuse.
