Technical data

#6001 COMBITHERM ELECTRIC INSTALLATION AND MAINTENANCE MANUAL
PG. 3
POSITIONING ON SITE
Before removing the oven from the pallet for
positioning on site, it is important to remove the drip
tray to prevent damage to the tray caused by the
lifting forks. The drip tray is fastened to the bottom of
the oven with three sheet metal screws as illustrated.
This requirement pertains to the following models.
This step does not
pertain to models
12•20ML and 20•20ML.
Lift the oven from the pallet
with a fork lift or pallet lift
truck positioned at the front
of the oven. To avoid
damage, position the lift forks
to the left of the condenser as
indicated in one of the two
diagrams shown below. For
additional damage protection,
the use of two wooden boards,
placed between the bottom of
the oven and the lifting forks,
is strongly recommended.
After the oven is correctly positioned
on site, reattach the drip tray.
MODEL
6•10
10•10
7•14
10•18
12•20
20•20
NET WEIGHT
285 lb (129 kg)
385 lb (175 kg)
405 lb (184 kg)
514 lb (233 kg)
665 lb (302 kg)
958 lb (435 kg)
15"
(381mm)
MODELS
6•10
10•10
7•14
10•18
CONDENSER
10" (254mm)
3"
(76mm)
8" (203mm)
CONDENSER
MODELS
12•20
20•20
MODELS 6•10ML
10•10ML
7•14ML
10•18ML
COMBITHERM
®
INSTALLATION
➤